killarny at gmail.com
Guest
|
 Posted: Sat Sep 13, 2008 10:26 am Post subject: [Freeswitch-users] dptools "read" command doesn't |
 |
|
I am having a hard time getting this command to work properly. Here is the c output from my test session, where I dial in to ext 500 with my sip client (Ekiga):
----
listening on localhost:8084
IPv4Address(TCP, '127.0.0.1', 36685): Connected
Caller: Killarny -
result was: Events Enabled
| Quote: | | Quote: | 'sendmsg\ncall-command: execute\nexecute-app-name: answer'
|
|
OK
| Quote: | | Quote: | 'sendmsg\ncall-command: execute\nexecute-app-name: read\nexecute-app-arg: 0 4 conference/8000/conf-pin.wav digits 10000 #'
|
|
OK
DTMF: 1
DTMF: 2
DTMF: 3
DTMF: 4
DTMF: 5
DTMF: 6
DTMF: 7
DTMF: 8
DTMF: 9
DTMF: 0
DTMF: *
DTMF: #
IPv4Address(TCP, '127.0.0.1', 36685): Connection was closed cleanly.
----
I couldn't figure out how to get read to function without passing a wav file (I plan to use TTS for the voice prompts, and I don't need a wav file to play here) so I just plugged in a random wav that comes with freeswitch for testing.
As you can see, freeswitch reports that the command executed properly, illustrated by the OK (which was a reply-text: +OK) but the read application doesn't seem to be functioning beyond playing the given wav file (and truncating the first half of it as well). Pressing digits in the sip client results in DTMF events being sent to the socket. Note that the DTMF events stop at # because I manually shut down the connection, not because of anything that freeswitch does.
Am I doing something wrong here? I feel like I'm following the available documentation given at http://wiki.freeswitch.org/wiki/Misc._Dialplan_Tools_read but I am having no luck. Is the read application basically a dead command, and should I be instead just using DTMF event output?
Any help that can be provided would be appreciated, thanks.
Killarny |
|
Search
