VoIP Mailing List Archives
Mailing list archives for the VoIP community |
|
| View previous topic :: View next topic |
| Author |
Message |
rs at runsolutions.com
Guest
|
 Posted: Tue Aug 25, 2009 9:18 am Post subject: [Freeswitch-users] Freeswitch & DAHDI Kernel drivers / H |
 |
|
Hello,
i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.
Is this current information? Can't I use dahdi kernel drivers for freeswitch? As the last update to the zaptel drivers is now nearly a year old (1.4.12) and development has, AFAIK, ceased and new stuff only gehts to dahdi, correct me please if I am wrong.
Second question,
is it possible to use this hardware:
00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Flags: bus master, medium devsel, latency 16, IRQ 10
I/O ports at e000 [disabled] [size=8]
Memory at ee001000 (32-bit, non-prefetchable) [size=256]
Capabilities: [40] Power Management version 1
Kernel modules: hisax
with openZap? I read in the wiki (openZap.conf_Examples) something about HFC 4 BRI, but i do not know if this is the same as the above mentioned card.
I have access to some pcmcia fxo, and pcmcia isdn cards, could they be used? I have as well an soekris board with two pcmcia slots, could i use this with an fxo pcmcia card to actually drive a small home - pbx with freeswitch?
I did not find answers for this questions in the wiki 
best regards
--
Raimund Sacherer
-
RunSolutions
Open Source It Consulting
-
Email: rs@runsolutions.com (rs@runsolutions.com)
tel: 625 40 32 08
Parc Bit - Centro Empresarial Son Espanyol
Edificio Estel - Local 3D
07121 - Palma de Mallorca
Baleares |
|
| Back to top |
|
 |
moises.silva at gmail.com
Guest
|
| Posted: Tue Aug 25, 2009 9:33 am Post subject: [Freeswitch-users] Freeswitch & DAHDI Kernel drivers / H |
|
|
On Tue, Aug 25, 2009 at 9:35 AM, Raimund Sacherer <rs@runsolutions.com (rs@runsolutions.com)> wrote:
| Quote: | Hello,
i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.
|
You did not search well enough. http://wiki.freeswitch.org/wiki/OpenZAP_OpenR2 , read note 5 there.
Â
| Quote: | Is this current information? Can't I use dahdi kernel drivers for freeswitch? As the last update to the zaptel drivers is now nearly a year old (1.4.12) and development has, AFAIK, ceased and new stuff only gehts to dahdi, correct me please if I am wrong.Â
|
both dahdi and zaptel work for FreeSWITCH and no headers are needed, we have our own.
Â
| Quote: |
00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board
Flags: bus master, medium devsel, latency 16, IRQ 10
I/O ports at e000 [disabled] [size=8]
Memory at ee001000 (32-bit, non-prefetchable) [size=256]
Capabilities: [40] Power Management version 1
Kernel modules: hisax
with openZap? I read in the wiki (openZap.conf_Examples) something about HFC 4 BRI, but i do not know if this is the same as the above mentioned card.
I have access to some pcmcia fxo, and pcmcia isdn cards, could they be used? I have as well an soekris board with two pcmcia slots, could i use this with an fxo pcmcia card to actually drive a small home - pbx with freeswitch?
|
I don't have experience with such hardware, cannot tell, may be someone else around here may know.
Â
--
Moises Silva
Software Developer
Sangoma Technologies Inc. | 50 McIntosh Drive, Suite 120, Markham ON L3R 9T3 Canada
t. 1 905 474 1990 x 128 | e. moy@sangoma.com (moy@sangoma.com) |
|
| Back to top |
|
|
rs at runsolutions.com
Guest
|
| Posted: Tue Aug 25, 2009 9:40 am Post subject: [Freeswitch-users] Freeswitch & DAHDI Kernel drivers / H |
|
|
On Aug 25, 2009, at 4:24 PM, Moises Silva wrote:
| Quote: | On Tue, Aug 25, 2009 at 9:35 AM, Raimund Sacherer <rs@runsolutions.com (rs@runsolutions.com)> wrote:
| Quote: | Hello,
i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.
|
You did not search well enough. http://wiki.freeswitch.org/wiki/OpenZAP_OpenR2 , read note 5 there.
|
Thank you, i did not see any link to OpenZAP_OpenR2, but this page explains a lot for me! |
|
| Back to top |
|
|
msc at freeswitch.org
Guest
|
| Posted: Tue Aug 25, 2009 11:10 am Post subject: [Freeswitch-users] Freeswitch & DAHDI Kernel drivers / H |
|
|
On Tue, Aug 25, 2009 at 7:35 AM, Raimund Sacherer <rs@runsolutions.com (rs@runsolutions.com)> wrote:
| Quote: |
On Aug 25, 2009, at 4:24 PM, Moises Silva wrote:
| Quote: | On Tue, Aug 25, 2009 at 9:35 AM, Raimund Sacherer <rs@runsolutions.com (rs@runsolutions.com)> wrote:
| Quote: | Hello,
i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.
|
You did not search well enough. http://wiki.freeswitch.org/wiki/OpenZAP_OpenR2 , read note 5 there.
|
Thank you, i did not see any link to OpenZAP_OpenR2, but this page explains a lot for me!
|
FYI,
I added a link to the R2 page on the main OpenZAP page.
-MC |
|
| Back to top |
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
Search
