VoIP Mailing List Archives

[merul at mac.com]

I'm new to FS, and experimenting with it on a constrained environment (PCEngines ALIX board running Voyage Linux 0.62).

So far, FS has compiled fine, and I can register multiple softphones and make calls between them, but I'm lost at how to configure a Sangoma U100 so I can make and receive calls over an analogue line.


I've installed the wanpipe drivers (3.5.4) from Sangoma, and the wanrouter utility detects the USB device, and I've compiled it to support the TDM API.


FS was compiled with the Openzap module - as best as I can tell.


I thought that I would be able to use the wancfg_tdmapi utility to configure the /etc/wanpipe/wanpipe1.conf and then use the generated configuration file as the basis for configuring autoload_configs/openzap.conf.xml.


However, the wancfg utility doesn't generate the wanpipe1.conf, and I'm stumped.


Any pointers would be much appreciated.


Best regards,


Merul