Sponsor: VoiceMeUp - Corporate & Wholesale VoIP Services

VoIP Mailing List Archives
Mailing list archives for the VoIP community
 SearchSearch 

[Freeswitch-users] Call Transfer Question


 
Post new topic   Reply to topic    VoIP Mailing List Archives Forum Index -> freeSWITCH Users
View previous topic :: View next topic  
Author Message
djbinter at yahoo.com
Guest





PostPosted: Sun Sep 06, 2009 9:27 pm    Post subject: [Freeswitch-users] Call Transfer Question Reply with quote

I am not sure if my question did not get post correctly earlier. I wonder whether anyone can give me any recommendations.

Here is the call flow:

I call from the PSTN (A party) into my Polycom phone (B-party) which is registered to FreeSwtich. The Freeswtich is setup not to route media as I have an SBC acting as a mirror proxy that will do all the NAT and media routing.

The inbound call is setup fine and there is two way voice. I then blind transfer from the Polycom to my Cell phone. I see the polycom send a SIP refer to Freeswitch and it sends a 202 accepted fine and that leg between the Polycom (B party) and the A party is torn down fine like its supposed to be. The Freeswitch places the outbound call (the number the call is transferring to C-party) and that call completes. However now there is one way audio between the A party and C party . I see RTP streaming back from the egress carrier where the call was transfered to so the A party can hear the C party but the C party cannot hear the A party . When I look at the SIP traces of the original inbound call from the A-party I see a SIP re-invite from free switch to place the call on hold (contains Freeswitch RTP address to I can hear hold music) while it is transferring the call and the A-party does hear on hold music from Freeswitch while the call is being
transferred. However I do not see a second re-invite from freeswitch to pass the media IP it got from the egress leg back to the original inbound leg. If my inbound gateway does not get a re-invite from Freeswitch to redirect its media to the new RTP address of of the egress carrier it will not do so hence the one way voice.

How do I get the Freeswitch to re-invite the original ingress leg once it gets the SIP 183 from the egress with the new RTP info ? Free switch is sending the first SIP re-invite to my inbound gateway with new media IP (IP of itself) so the A-party can hear on hold music , but does not send a second re-invite to my inbound gateway after it receives the new RTP address from the egress carrier for the call that was transferred back out.

Thank you.





_______________________________________________
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
Back to top
Display posts from previous:   
Post new topic   Reply to topic    VoIP Mailing List Archives Forum Index -> freeSWITCH Users All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group

VoiceMeUp - Corporate & Wholesale VoIP Services