VoIP Mailing List Archives

[shiyanov at gmail.com]

Hi all!

As it stays in wiki: 
...
HEARTBEAT
Status information for freeswitch trigerred by freeswitch's heartbeat every 20 seconds.
...


Is there any way to customize timeout of HEARTBEAT events?





Thanks in advance,
Artem

[diego.viola at gmail.com]

Maybe you want enable_heartbeat or sched_heartbeat from mod_dptools?

You can pass your parameters in second to these two.

Example:

<action application="enable_heartbeat" data="1"/>
<action application="sched_heartbeat" data="1"/>

Where 1 in this case is the number of heartbeats per seconds.

You can use that example on the Dialplan XML but you can also use it on mod_event_socket outbound, etc.

Best regards,

Diego



On Sun, Oct 11, 2009 at 4:59 PM, Artem Shiyanov <shiyanov@gmail.com (shiyanov@gmail.com)> wrote:

[mike at jerris.com]

On Oct 11, 2009, at 5:44 PM, Diego Viola wrote:

[shiyanov at gmail.com]

Michael, Diego,
thanks for the rapid answers!

As far as I understand, "enable_heartbeat" app is launching SESSION_HEARTBEAT events that will stop when the call will be cleared. Also I "heard" that "enable_heartbeat" works only for calls with proxied media.

What I want is to monitor FreeSwitch status: is it alive and what is the system status message. This info is provided in HEARTBEAT event gracefully but in constant time period = 20 sec. So the main question is- how to customize this period?


Artem



On Mon, Oct 12, 2009 at 2:52 AM, Michael Jerris <mike@jerris.com (mike@jerris.com)> wrote:

[anthony.minessale at g...]

it works in either case with or without media
the syntax for setting the frequency was answered above.


On Mon, Oct 12, 2009 at 12:38 AM, Artem Shiyanov <shiyanov@gmail.com (shiyanov@gmail.com)> wrote:

[shiyanov at gmail.com]

Sorry for my foolishness but I stil can't grasp it.
I'm developing app based on inbound mod_event_socket and I don't know how to run "enable_heartbeat" or " sched_heartbeat" without specifying any alive session uuid. I tried to use "create_uuid" and send mentioned  commands to the created uuid  but this approach doesn't work. I do need to monitor the FS state itself rather then any particular call.

Please, enlighten me!
Artem



On Mon, Oct 12, 2009 at 6:26 PM, Anthony Minessale <anthony.minessale@gmail.com (anthony.minessale@gmail.com)> wrote:

[msc at freeswitch.org]

On Tue, Oct 13, 2009 at 8:32 AM, Artem Shiyanov <shiyanov@gmail.com (shiyanov@gmail.com)> wrote:

[shiyanov at gmail.com]

Finally!!
Thank you Michael, I didn't know about "status" app. It satisfies all my desires.

And again,
thanks for all the community for the strong support!

Artem




On Tue, Oct 13, 2009 at 10:48 PM, Michael Collins <msc@freeswitch.org (msc@freeswitch.org)> wrote:

[anthony.minessale at g...]

the heartbeat you were seeing that needs a uuid was the session heartbeat which is a per-call heartbeat.
indeed, the system heartbeat is not customizable.


On Wed, Oct 14, 2009 at 1:31 AM, Artem Shiyanov <shiyanov@gmail.com (shiyanov@gmail.com)> wrote: