kevin at johnnyvoip.com
Guest
|
 Posted: Wed Jun 17, 2009 2:09 pm Post subject: [Freeswitch-users] Solaris 10 - Install Instructions Needed |
 |
|
I was wondering if anyone had a set of detailed step-by-step instructions on how to get FS up and running on Solaris 10 from a base Solaris install. I understand that there are a few pieces required to be able to build FS as described on the wiki (http://wiki.freeswitch.org/wiki/Installation_Guide#Solaris) but it skips over the details of each step. If someone could fill in the details or provide me with some help it would be greatly appreciated.
Also, if there are any differences between working on an x86 vs a SPARC platform it would be good to have notes on the different steps that should be taken including any configuration variables that would optomize FS for x86 or SPARC CoolThreads machine.
I have attached a whitepaper describing the benefit of UltraSPARC T2 processors running VoIP applications for anyone's interest. This whitepaper is my motivation for wanting to try FS on Solaris.
Regards,
Kevin Green
JohnnyVoIP
350 Legget Drive
Kanata, ON, Canada
K2K 2W7
Phone: 613 271 5993 Ext 1203 |
|
Search
