VoIP Mailing List Archives

[regs at kinetix.gr]

Hi,

How can my FS accept inbound SIP calls from other gateways
without the need of a registration from their part? I only need to be able
to accept inbound calls from specific gateway IPs. I tried creating my
own profile
and gateway but it fails : "Error Creating SIP UA for profile: myprofile"

Can someone give me some first-step directions?


_______________________________________________
Freeswitch-users mailing list
Freeswitch-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org

[birgit at westhawk.co.uk]

Hi,

I have no idea what that error message means, sorry.

However, we have a setup where we only accept SIP from a single source
and use ACL (and not a sip gateway profile), see:
http://wiki.freeswitch.org/wiki/Acl

Note, the thing that tripped us up was that incoming SIP on port 5060 by
default comes in on the 'internal' gateway, and 5080 as external. We
switched the port numbers around.

Hope this helps.

Cheers, Birgit


On 04/11/08 16:24, regs@kinetix.gr wrote:

[brian at freeswitch.org]

You need to first make sure the profile is on its own IP and port.
Then I would recommend you turn auth-calls=false or use ACL's to
authenticate the callers.

http://wiki.freeswitch.org/wiki/ACL


The external profile is a good one to look at for a base.. it listens
on port 5080 and doesn't auth calls... and sends them to the public
context.

/b


On Nov 4, 2008, at 10:24 AM, regs@kinetix.gr wrote:

[regs at kinetix.gr]

Is it compulsory that I use different ports for different profiles?
What if I want to use the same ports for my authenticated users and the
non-authenticated ones?

Birgit Arkesteijn wrote:

[mike at jerris.com]

On Nov 4, 2008, at 11:47 AM, regs@kinetix.gr wrote:

[anthony.minessale at g...]

If you want to make your life easier, yes 2 profiles one 2 difft ports (or use 2 profiles with 2 ip and same port)
If you insist on using both types (auth and not auth) on the same profile then you can challenge from the dialplan (see wiki) but its much more complicated.

It makes sense to run authenticated calls on a non standard port because you can either use srv records to hide the port anyway or since it's a one time configuration setting in the phone you will never think about that port again. If its a matter of OCD to have the port be 5060 there's nothing else I can do.


On Tue, Nov 4, 2008 at 10:47 AM, regs@kinetix.gr (regs@kinetix.gr) <regs@kinetix.gr (regs@kinetix.gr)> wrote: