VoIP Mailing List Archives

[c_cav_01 at yahoo.com]

My dialplan is pretty simple. I have a single trunk with a vonage softphone
DID (1303... we'll call it main) and a "virtual" DID (1816...) which rings
the softphone DID. All incoming calls show up as from softphone DID but the
sip_to_user holds the actual number dialed so I can enter the dialplan
properly.

I have 2 extensions in my directory/extensions, one for each of the DID's.
The extensions check sip_to_user for match and that works great. I match on
([0,1]?)(<10 digit did>) and it enters the dialplans correctly, plays the
right music for each DID while the dial is occuring, so all that works. The
bridge to user/$2@$${domain} also works fine.

The continue_on_fail is set properly so on no answer call_timeout hits (at
25 secs), and goes to voicemail... works also for both numbers.

transfer to voicemail is as follows
<action application="answer"/>
<action application="voicemail" data="default $${domain} $2"/>

which should be pulling $2 from the condition check shown above, which it
does, cuz the bridge works...

When I call in on main DID, I get "leave a message for 1303..." The Main
DID..
When I call in on virtual, I get "leave a message for 1303..." The Main DID
rather than the 1816....

How can I get voicemail to use the correct DID. HELP!!
--
View this message in context: http://www.nabble.com/Wrong---in-voicemail-tp20791453p20791453.html
Sent from the Freeswitch-users mailing list archive at Nabble.com.


_______________________________________________
Freeswitch-users mailing list
Freeswitch-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org