vincent.delporte at bi...
Guest
|
 Posted: Mon Jan 07, 2008 2:02 pm Post subject: [asterisk-users] [Asterisk 1.2 + TDM FXO] Incoming call not |
 |
|
Hi
On an old IBM Netvista thinclient, the TDM card doesn't detect
incoming calls, although the card seems to be detected, and correctly
configured:
pbx asterisk # lspci
00:03.0 Communication controller: Tiger Jet Network Inc. Tiger3XX
Modem/ISDN interface
# cat /etc/zaptel.conf
fxsks=1
loadzone=fr
defaultzone=fr
# ztcfg -vv
Zaptel Configuration
======================
Channel map:
Channel 01: FXS Kewlstart (Default) (Slaves: 01)
1 channels configured.
# zttool (with the phone line plugged into the FXO port)
OK Wildcard TDM400P REV E/F Board 1
=> Select
Current Alarms: No alarms.
IRQ Misses: 0
Bipolar Viol: 0
Tx/Rx Levels: 0/ 0
Total/Conf/Act: 0/ 0/ 0
There is dialtone on the line, and the green LED is lit up after
loading the Zaptel driver, but when I connect to Asterisk, nothing is
reported when I call into the FXO port.
Is the motherboard not compatible with this PCI card? Are there
settings I can try to get the card to detect the call?
Thank you. |
|
Search
