VoIP Mailing List Archives

[rentorbuy at yahoo.com]

Without call-limit defined, when a sip extension calls
another sip extension then "show hints" shows that
both are InUse (as expected). When one of them hangs
up, both hints status become "Idle" (as expected).

With call-limit=1 for each SIP extension:

the caller is always Idle while the callee is InUse.
Is this behavior normal?

Doesn't sound right because if, during the latter
conversation, another extension calls the "caller"
then it will ring (but shouldn't since call-limit=1
for everyone).

The worst case is:
if I call from SIP/6010 to SIP/4053, 4053 puts 6010 on
hold, 6010 hangs up, then "show hints" shows that 6010
is Idle but 4053 is Busy and stays like that even if
the 4053 softphone re-registers. The only way to clear
this Busy state is to restart the asterisk daemon.
"show channels" says that there are 0 active channels
and 0 active calls.

I am running asterisk 1.2.27.

I require call-limit=1 or similar option because I
would like the extensions to accept only one call at a
time (whether receiving or calling). It can't be done
on the client side because the softphones used don't
allow that in their configuration (using SJphone).

Does call-limit have a known bug (at least for
call-limit=1)?

Thanks,

Vieri
____________________________________________________________________________________
Looking for last minute shopping deals?
Find them fast with Yahoo! Search. http://tools.search.yahoo.com/newsearch/category.php?category=shopping

[oej at edvina.net]

Remember that if you enable call-limit=1 with a type=friend, you will
actually have one inbound call (on the user)
and one outbound call (on the peer).

Groupcount in the dialplan is propably a better solution to enforce
call limits than anything in the SIP channel.
It works with all channel drivers too, as an extra benefit.

Regards,
/Olle

[rentorbuy at yahoo.com]

--- Johansson Olle E <oej at edvina.net> wrote: