VoIP Mailing List Archives

[ebielaczyc at gmail.com]

I'm just wondering if any one else has tried to successfully install
Asterisk on Ubuntu inside VM.

I've installed Ubuntu without incident or error. Even the install of
Asterisk is relatively straightforward as it is maintained in one of
the repositories. But when I attempt to start Asterisk I get a nice
Segmentation Fault. I've narrowed down the problem somewhat. If I
disable modules from automatically loading in modules.conf, e.g.
autoload=no, Asterisk will start. If I keep the default, autoload=yes,
Asterisk fails to start (seg fault). I can't find in any of the other
config files where Asterisk may be trying to load a module and
therefore crashing the system.

I'm really just trying to experiment with different features and
configurations of multiple Asterisk machines and would prefer to do
that in virtual space. I'm willing to make my configs available. I
just thought I'd drop this email on the list hoping for the chance
that someone has dealt and corrected this problem.

Thanks much in advance.

--
Ein Bielaczyc <ebielaczyc at gmail.com>

NOTICE: This E-mail (including attachments) is covered by the
Electronic Communications Privacy Act, 18 U.S.C.2510-2521, is
confidential and may be legally privileged. If you are not the
intended recipient, you are hereby notified that any retention,
dissemination, distribution or copying of this communication is
strictly prohibited. Please reply to the sender that you have received
the message in error, then delete it.

[alex.robar at gmail.com]

If you leave all of the modules enabled, which one does it have a
problem with? You should be able to run "asterisk -vvvvvc" to see where
it stops loading. The last line or so should give you the module that it
tried to load before it failed. Based on the last time I tried to
install under Ubuntu, you're probably failing to load the Zap module.
Since you're in a VM and it's unlikely that you're using Zap for
anything, you can disable chan_zap.so and see if your Asterisk starts
properly then.

Cheers,
AR
On Sun, 2008-03-30 at 20:50 -0400, Ein Bielaczyc wrote:

[tzafrir.cohen at xorco...]

On Sun, Mar 30, 2008 at 08:50:10PM -0400, Ein Bielaczyc wrote: