VoIP Mailing List Archives

[pgudge at gmail.com]

Update,

Still not sorted, I have checked some tools on the TrixBox and using
the wanrouter I was able to check the voltage on lines.
The three result are when there is no call active

[root at asterisk ~]# wanpipemon -i w1g1 -c astats -m 1
------- Voltage Status (FXO,port 0) -------
VOLTAGE : 0 Volts

[root at asterisk ~]# wanpipemon -i w1g1 -c astats -m 2
------- Voltage Status (FXO,port 1) -------
VOLTAGE : 49 Volts

[root at asterisk ~]# wanpipemon -i w1g1 -c astats -m 3
------- Voltage Status (FXO,port 2) -------
VOLTAGE : 52 Volts


The following three are when a call is placed

[root at asterisk ~]# wanpipemon -i w1g1 -c astats -m 1
------- Voltage Status (FXO,port 0) -------
VOLTAGE : 1 Volts

[root at asterisk ~]# wanpipemon -i w1g1 -c astats -m 2
------- Voltage Status (FXO,port 1) -------
VOLTAGE : 7 Volts

[root at asterisk ~]# wanpipemon -i w1g1 -c astats -m 3
------- Voltage Status (FXO,port 1) -------
VOLTAGE : 7 Volts



Line 1 shows no Volts when on the hook, but off the hook 1 Volt where
as Lines 2 and 3 (working fine) show the same results with 49/52Volts
on hook and 7Volts off hook.

Does this help anyone?

Thanks, PaulG.



On Thu, Mar 20, 2008 at 8:44 AM, David Quinton <gname2 at bizorg.co.uk> wrote: