Sponsor: VoiceMeUp - Corporate & Wholesale VoIP Services

VoIP Mailing List Archives
Mailing list archives for the VoIP community
 SearchSearch 

[asterisk-users] DTMFR2- UNICALL


 
Post new topic   Reply to topic    VoIP Mailing List Archives Forum Index -> Asterisk Users
View previous topic :: View next topic  
Author Message
gustavo at utopixnetwo...
Guest





PostPosted: Fri Apr 18, 2008 9:55 am    Post subject: [asterisk-users] DTMFR2- UNICALL Reply with quote

Hi Jessi,
It seems that I have the same problem. I'm using an Asterisk with a
TE120P card with R2 cas signalling. The channels are working ok but the
PBX on the other side shows MFAS alarm. I have dig the code of the
zaptel drivers but I have not found anything where you can change the
bit pattern of the timeslot 0.

I have found something in zaptel-base.c but I m not sure if this code is
relevant to the problem we have.

...

chans[ch.chan]->sig = ch.sigtype;
if (chans[ch.chan]->sig == ZT_SIG_CAS)
chans[ch.chan]->idlebits = ch.idlebits;
else
chans[ch.chan]->idlebits = 0;

...

Have you found anything to solve the problem?

Best regards,

Gustavo
Back to top
Display posts from previous:   
Post new topic   Reply to topic    VoIP Mailing List Archives Forum Index -> Asterisk Users All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group

VoiceMeUp - Corporate & Wholesale VoIP Services