VoIP Mailing List Archives

[asterisk at abraxas.si]

Hi guys,

I have few queues configured on my PBX that have:

monitor-format=wav
monitor-join=yes

My problem is that the volume of the clients who are calling into these queues is slightly higher than the volume of the agents.

Is there any way to modify the volume (either lower the volume of the clients, or increase the volume of the agents) while doing the join of the "-in" and "-out" files into one recording?

I'm using version 1.2.9, which I think uses soxmix for joining the files?

Thanks, Alex

[dbackeberg at gmail.com]

On Tue, May 13, 2008 at 10:42 AM, Asterisk <asterisk at abraxas.si> wrote:

[asterisk at abraxas.si]

Thanks. If I find out some settings for soxmix, do you maybe know where can I change Asterisk settings for soxmix (parameters)?

Regards, Alex

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com [mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of David Backeberg
Sent: Tuesday, May 13, 2008 5:35 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] Queues, monitor-join=yes, and volume

On Tue, May 13, 2008 at 10:42 AM, Asterisk <asterisk at abraxas.si> wrote:

[dbackeberg at gmail.com]

You can call the sox binary directly from your dialplan, or any other
binary that fits your needs. If you post your dialplan where you're
doing the recording, we can give input about where to put the calls to
sox.

On Wed, May 14, 2008 at 4:16 AM, Asterisk <asterisk at abraxas.si> wrote: