VoIP Mailing List Archives

[daldworth at teliax.com]

I'm looking for the most effective way to make sure I'm always forcing
inband dtmf and PCMU on the PSTN <-> FS side of inbound and outbound
calls. FS is always in the middle of the media. The FS <-> SIP UA
(customer) side will be rfc2833 and whatever the negotiated codec for
that particular UA happens to be. I know I can set <param name="codec-
prefs" value="PCMU"/> and <param name="inbound-codec-negotiation"
value="greedy"/> in the internal sip profile but won't the external
sip profile settings override this when UA dial out? (they hit the
external profile first in this case)

I'm basically fishing for suggestions on the best way to use start/
stop_dtmf for the inband detection and start/stop_dtmf_generate for
sending the dtmf.

In asterisk this would have been accomplished by setting up separate
stanza's in sip.conf and setting the dtmfmode= and allow= line per the
respective legs of the calls. So, calls coming to/from the PSTN would
have dtmfmode=inband and allow=ulaw, meanwhile UA's connecting to
asterisk would have dtmfmode=rfc2833 and allow=ulaw, gsm, etc.

Why on earth would I be doing this? Well, in the interest of keeping
the explanation short, we are limited to the common denominator of all
our upstream PSTN carriers and they (or their equipment rather) always
support this setup.

Thanks for any advice.

David


_______________________________________________
Freeswitch-users mailing list
Freeswitch-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org