VoIP Mailing List Archives

[jim at evolutiontel.net]

should open a jira on this? Did you guys need any more info?

- original message -
Subject: Re: [Freeswitch-users] Calls drop immediately when terminator forces G.729 Codec.
From: Brian West <brian@freeswitch.org>
Date: 05/06/2009 00:35

Try SVN trunk I cna tell you're using older code!

/b

On Jun 4, 2009, at 7:23 PM, Jim Burke wrote:

[brian at freeswitch.org]

DId you update to trunk?

/b

On Jun 5, 2009, at 3:06 AM, Jim Burke wrote:

[jim at evolutiontel.net]

Yup sure did, same result

- original message -
Subject: Re: [Freeswitch-users] Calls drop immediately when terminator forc es G.729 Codec.
From: Brian West <brian@freeswitch.org>
Date: 05/06/2009 14:10

DId you update to trunk?

/b

On Jun 5, 2009, at 3:06 AM, Jim Burke wrote:

[anthony.minessale at g...]

it is using G729a which is not the correct RFC  value that goes with payload 18 so it's moving it to 96 as if it's some other
codec.

the only thing you can do is get them to stop using invalid data in their sdp
or hack it to replace "G729a" with "G729 " before it's too late.


On Fri, Jun 5, 2009 at 6:25 PM, Jim Burke <jim@evolutiontel.net (jim@evolutiontel.net)> wrote:

[mrene_lists at avgs.ca]

Linksys still uses G729a in their sdp, but you can change it in the admin panel (if thats what you have)

Math

On 5-Jun-09, at 7:53 PM, Anthony Minessale wrote:

[jim at evolutiontel.net]

Yes, the terminator is Linksys so will change it and test.

Noticed there is a list of mime types associated with FS and G729a was not listed, does this have anything to do with the root cause?

- original message -
Subject: Re: [Freeswitch-users] Calls drop immediately when terminator forc es G.729 Codec.
From: Mathieu Rene <mrene_lists@avgs.ca>
Date: 05/06/2009 23:56

Linksys still uses G729a in their sdp, but you can change it in the
admin panel (if thats what you have)

Math

On 5-Jun-09, at 7:53 PM, Anthony Minessale wrote:

[brian at freeswitch.org]

G729a is 100% INVALID in the sdp on codec 18.

/b

On Jun 5, 2009, at 9:25 PM, Jim Burke wrote:

[jim at evolutiontel.net]

Gents,

Thanks for your input on this.....much appreciated.

Changing the codec from G729a to G729 before the call hits FS did the
trick. Calls are now going through correctly.

Cheers,
Jim

On Sat, Jun 6, 2009 at 12:32 PM, Brian West<brian@freeswitch.org> wrote: